Item Type: Immobiliser Emulator After decoding of for computer using for RESET TOOL or by entering security code, in most cases you can start engine, but some of computers can not operate without immobilizer code stored in their memory. Crude oil EDC15C3, DCU3R and MSA15, petrol SIRIUS32 (except those for 1.4Lengine) and FENIX5 for 2.0L 16V engine require working unlocked (with good key) immobilizer unit or for immobilizer emulator. Fitment: Fit for models, fitted with single-data-wire coded immobilizers. from 1994 . until the introduction of CAN (2001 to 2003, dependingon exact model). Immo pin code is not required Decode the ecu using the for renualt ecu decoder. Only 3 wires to connect: Ignition, Ground and Data. Small module size Module is designed to be left permanently connected to the car. Non-volatile memory means no data loss, even after flat batteries or for jump startS. Module can be used again if need be. Petrol ECU's For FENIX3B For FENIX5 For SIRIUS32 For SAFIR (55pin) For SAFIR2 (35pin) For CH. MOTRONIC MP7.0 For IAW 06R For IAW 8R.30 For ECU's For CH. MSA15.5 (DTI) For CH. EDC15C3 () For LUCAS DCU3R (1.9D) Coded fuel cut-off valve (1.9D DDS) rcuit. Turn ignition back on, the car should now start. Colour: as shown Material: Plastic Package Contents: 1 x Emulator Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.
Fruugo United Kingdom