This is my own rendition if the GBRS Hydra dual riser mount, I have modelled this myself on Fusion 360 and printed it with PLA+ I wanted to make a riser that had the optic rail higher than the laser/light rail in front, since many red dots get partially occluded my the PEQ in front. This also means you're able to use a much greater variety of red dots / scopes with your setup without your PEQ box getting in the way of your sight picture. This model has been printed with 4 walls, 55% cubic infill and, most importantly, at a 45° angle, which massively improves strength of the print and reduces the chance of failure along layer lines. It comes with the necessary nuts and bolts to secure it onto 20mm picatinny rails.
eBay