1.Shell material :PC 2.Voltage :5V 3.current :15mA 4.Max current (peak):300mA 5.Shell color :White translucent 6.Cable length :Short:200mm Long :1000mm 7.Wire: 3pin: Green :-GND RED:+5V Orange:Signal cable 2pin: Black:-GND White :Zmin 8.The 3D Touch auto leveling sensor is a device that uses the Hall edect to achieve leveling .The position of the point can be obtained by touching the point on the heated bed ,and then compensated by adjusting the Z-AXIS height during printing ,Printing can also be achieved even though the patform is not flat . 9. 3D Touch is an auto bed leveling sensor for most open-source 3D printers.Such as ANET A8,CR10 and Ender 3 series,ANYCUBIC i3 Mega,Geeetech A10. 10.The 3D Touch could work with nearly any kind of bed materials,s.
eBay