Feature: DC Overload Protector used for overcurrent protection, short circuit protection, motor blocked protection, auto-stop overload protection. The input voltage is DC 6V-28V. Output current: 8A max (resistance load); 5A max (motor load) The Protected Delay Time: 0-20s The Current Limitation: 0.2A-10A The Reset Time: 1-600s (automatic mode) Include Power-on LED and current-limit-protected alarm LED. Operating instruction: Before you attempting to wire the protector, make sure power is off. WARNING: DO NOT REVERSE POSITIVE AND NEGATIVE POWER LOADS.THIS WILL DAMAGE THE CONTROLLER. 1. Connect wires refer to the "wiring diagram" (NO. n picture). 2. Install the jumper to"Auto" or "Manual" modes. (Default is automatic mode.) 3. Set parameters of Current Limitation, Delay Time and Reset Time (.
eBay