How to use 1. The surface around the rip or hole should be dry, clean and free from any dirt particles. Wipe with a solvent to remove grease. 2. Align the hole as best as possible to narrow the hole, you can use other tapes or weights around the hole to stop it opening more and this will keep the One Seal in place while it fully bonds. then apply a layer of One Seal at least 20mm in each direction from the cut 3. Try and eliminate movement for 15-30 mins (depending on the air temperature) & then apply a thick layer of One Seal again & allow to dry for 6 hours. After 6-7 hours you can remove these temporary fastenings & use your product again. 4. Full strength is achieved after 24 hours. If the hole is longer than 30mm, then use the reinforcing mesh and apply before the first layer of One Seal.
eBay