Surface Ceiling Mount for Ubiquiti Networks U6 Mesh Access Point This is a heavy duty 3D Printed Ceiling Mount custom made for the Ubiquiti U6 Mesh Access Point. The base of the mount fastens to any surface using (3) perimeter screws, and holds the device using a single 1/4-20 screw from the back. The aesthetic cone installs by sliding over the device and spin-locking in place. The sleek design allows you to route the Ethernet cable directly out from the back of the mount up into the ceiling for a clean install. You can also route the cable from the side which is great for corners. This adds approximately 12mm height to the mesh and the footprint of the decorative exterior cone is 111mm Free 30 Day Hassle-Free returns, we want you to be 100% satisfied! Are you looking for something s.
eBay