For motor vehicle workshops: they Can use the bridge to exclude error diagnosis at Airbag and belt tensioner defects !!!! The assembly is very easy to pull off the cable from your defective component and clamp the bridge behind the plug, with the included Turning electricity. It is not to be considered polarity. Or plug the bridge using small MQS pen (contacts MQS Abbey contacts not included Or simply remove the insulation on the Airbag or belt tensioner cable at one point and solder the bridge in between. Then the error should be deleted this then you know that your Airbag control unit is OK and it is due to the Airbag / belt tensioner The test tool may only be used for test purposes or Troubleshooting can be used! Working on the entire Airbag system may only be carried out by trained sta.
eBay