To enable the new remote control you need to intervene on the receiving control unit to access the buttons 1. Press and release the P1 button (on the receiver): the L1 LED 2. While the receiver LED is flashing, press the button of the new radio control (to be coded) that you want 3. The LED Ll (on the receiver) will light up for approximately three seconds as confirmation of correct memorization of the code. 4. The LED Ll will start flashing again waiting for a new one radio control, if none are received within 5 flashes the receiver will automatically exit the procedure 5. Follow the same procedure for the other button (P2 on the programming phase indicates that the radio control is already 2. All the LEDs of the receiver flash alternately Contact usAdd to favouritesVisit the StoreSign up.
eBay